Sea & Sea YS-D2J Strobe

Ball Mount Strobe Adaptor、Diffuser100、Diffuser120, Red filterx2
* When the YS-D2 is used with a camera with built-in flash in housing, use the Fiber-Optic Cable.
* Use of genuine SEA&SEA Fiber-Optic Cables is recommended. SEA&SEA strobes may not function properly if a third-party Fiber-Optic Cables are used (functions such as TTL auto exposure in particular).

RM 2,750.00 2750.0 MYR

RM 2,750.00

Add to Cart

Share


Excellent night-time visibility. The illuminated control panel is ideal for night diving

 Color of illumination changes to indicate mode: aqua blue (in DS-TTL mode), blue (in slave TTL mode), orange (in manual pre-flash mode) and Green (in manual mode without pre-flash). You can check which mode the strobe is set even under pitch-black conditions.

In Manual non pre flash mode


In manual pre-flash mode


In slave TTL mode


DS-TTL ll automatic exposure control with improved accuracy and stability

 SEA&SEA’s own automatic exposure control system, DS-TTL ll, has been further improved. Tuning light emitting timing in detail and adding light emission detection function, the accuracy of automatic TTL exposure has been noticeably improved. Previously, TTL photography was difficult with the lens’s aperture wide-open (maximum aperture) and images were likely to be overexposed. It is now possible to give a low powered flash so the correct exposure can be easily achieved with the YS-D2.

Specifications

 

 [Guide Number (ISO 100/m) (land)] : 32, 24 (with Diffuser 100 attached), 20 (with Diffuser 120 attached)

[Beam Angle] : 80°x80° (without Diffuser), 100°x100°(Diffuser 100), 120° x 120° (Diffuser 120)

[Batteries] : 4xAA A: 6V Ni-MH: 4.8V

[Number of Flashes *1] : A: 150 Ni-MH: 200

[Recycle time (full) *2] : A: 3.0 sec. Ni-MH: 1.5 sec.

[Color temperature] : 5600K

[Color temperature w/diffuser] : 5250K

[Depth rating] : 100m / 330ft

[Dimensions (WxHxD)] : 89x111x141mm / 3.5 x 4.8 x 5.6 inches (excluding YS-base)

[Weight] : 618g / 21.0oz (w/o batteries) (excluding YS-base)

[Underwater weight] : Approx.+40g / 1.4oz (incl. batteries)

[Others]

Exposure control: DS-TTL II, Slave TTL, Light level control dial (GN): 1 / 1.4 / 2 / 2.8 /4 / 5.6 /8 / 11 / 16 / 22 / 32 (11 steps)

Pre-flash control: Equipped with pre-flash cancel mode

DS-TTL II function

Slave function

Auto power OFF function

Sync cord: 5-pin Sync cord/N, Fiber-Optic Cable

Over-pressure relief valve

LED target light (output is adjustable in 2 steps)

Audible charge signal

*1 Number of flashes and recycle time depends on the battery brand, temperature and frequency of use.

*2 Number of flashes and recycle time of Ni-MH batteries were tested on 2400 mAh batteries.

Share